Winter Catalog

accessories body & chassis engine electrical & ignition controls fuel & intake rewind clutch drive rear suspension front suspension traction mini sleds chemicals FUEL & INTAKE tools & shop trailer & towing 540 These trick new flapper valves are installed in the top of the air box on Ski-Doo 800 models to provide additional air flow to the engine. They are activated by air box vacuum.  When the stock intake begins to plug in deep powder snow conditions, these valves open to deliver the necessary air flow that the engine demands.  This substantially improves consistency when running in deep powder snow conditions. Sold per pair. POWDER VALVES TM For Ski Doo XP 800 SP14134 2008-16 XP 800 Carb 59.95 236383 2011-14 XP 800 E-TEC 59.95 236157* Pre-Filter 39.95 SP14134 236383 236157 * Will only work with PART # SP14134 PRE-FILTER For Ski Doo REV The stock air intake of the REV is known for plugging when running in powder snow conditions. Eliminate this plugging problem with the SLP powder snow pre-filter. This unique material repels powder snow and water while passing air right through. A must for anyone riding in powder snow conditions. SP14198 39.95 236572 Fits 13-17 800 E-TEC Summit XM 139.95 236572 Fits 13-17 800 E-TEC MXZ/Renegade XS 139.95 HIGH FLOW TM INTAKE For Ski Doo XP except E-TEC HIGH FLOW TM INTAKE For Ski Doo 800 E-TEC XM/XS Chassis This High Flow™ Intake Kit for the Ski-Doo XP increases the air intake surface area by 33% to reduce the chance of the intake plugging in powder snow conditions. It is located higher than the stock intake and within reach of the rider so that any snow that collects on it can be easily wiped away. This kit consists of a molded plastic adapter that seals between the stock air box and the hood along with an intake grate that utilizes our pre-filter material that repels snow and water while passing air right through. This kit is a must for anyone riding powder snow conditions. This High Flow™ Intake kit for the XM/XS Ski-Doo models adds additional intake surface area to provide more available cold air to the engine for more horsepower and running consistency. It utilizes our famous Powder Valve™ system that is vacuum operated and only opens when the demand of theengine places a vacuum on the air box. It combines these with a filter placed in the side of the cowling just in front of the fuel tank and above the tunnel. The kit fully seals the surrounding area to insure that only cold air is being induced into the system. It is especially beneficial when running in deep snow condi- tions where the stock filters are being plugged. It is also highly recommended to compliment other horsepower adding parts. SP14129 89.95 SLP HOT / COLD AIR VENT For All Brand Snowmobiles Belly Pan Hot Air Escape or Cold Air Intake Vent This streamlined vent adds a sporty appearance, but most important, it removes unwanted hot underhood air that robs performance. Can be located on any flat or near flat surface (3¼” x 12 3/8”) for hot air escape or reversed for cold air inlet. Supplied in black, but is paintable. Sold each with fasteners. SP32304 25.95