Winter Catalog

REAR SUSPENSION accessories body & chassis engine electrical & ignition controls fuel & intake rewind clutch drive rear suspension front suspension traction mini sleds chemicals tools & shop trailer & towing 890 UNIVERSAL REAR SUSPENSION HANGER Relocate your rear suspension easily with the use of these rear suspension hangers. Manufactured from high tensile steel and powder coated, these hangers not only look good, they are very strong and lightweight. Sold per pair. SP32412 54.95 SLP TRACK / HIFAX ANTI-WEAR PADS Increased performance! These wear pads reduce drag and wear on Hifax. Designed for the new Polaris and Ski-Doo Long Tracks that are not equipped with windows or wear clips on each cross bar. Without these anti-wear pads you will have higher Hifax temperature, more drag against the track and even depositing rubber on the Hifax. Eventual damage to the track is also possible. DESCRIPTION PART # Pad, washer and nut SP25101 0.95 each Pack of 40, for 136, 144 and 151 tracks SP25102 38.00 pkg Pack of 32, for 121 track SP25103 30.40 pkg HIPERFAX TEFLON SLIDES Our Hiperfax Slide has been designed, engineered and developed right here in Maine by an avid snowmobiler with the knowledge of what it takes to produce a slide that will give longer life, less drag, better fuel mileage, and more speed and here it is! Priced and sold in pairs. TIPS FOR INSTALLATION: 1) If track clips are sand pitted, rusted or have plastic adhered to them, clean thoroughly with sandpaper or other appropriate method. 2) Tracks must have clips on every crossbar (not all new tracks have them). 3) Run 50-60 miles in good snow conditions to break in the Hiperfax for best results. WARRANTY: Warranty is limited to defects in workmanship or material. Improper installation, suspension adjustment, track adjustment, too many studs on the track, poor quality track clips, lack of track clips or normal wear are not covered by warranty. COMMON REASONS FOR PREMATURE WEAR TOANY SLIDES, (STOCKHYFAXORHIPERFAX): 1) Track is too tight at lower speeds and just right at high speeds (this is caused by either a worn out track or more often than not, overstudding). 2) Pitted track clips gouge the slide 3) Track clips are missing. 4) Another possible reason for excessive heat being created and causing premature wear is small track windows. Many tracks are offered with windows so small that not enough airflow is getting through and onto the slide. Airflow can make a significant difference in any slide’s temperature. Ideally, the larger the windows, the better. ATTENTION: Hiperfax that are a little shorter than stock lets the track transition from the flat surface of the rail to the wheel radius easier than when cut to the factory length. Many track extension kits will leave a 6 void (no rail or slider) between the rear of the slider and the rear idler wheels. Many racers cut their slides shorter than their rails to enhance performance. PROFILE 11 PART # YEAR PROFILE LENGTH MODEL COLOR TRACK POLARIS PC2509 149.50 96-98 #11 43-1/4 X-10 STD PURPLE 121 TRACK PC6109 149.50 99 ON #11 44-3/8 X-10 STD PURPLE PC5607 149.50 96 ON #11 49-1/2 X-10 SKS BLUE PC1909 149.50 UP TO 95 #11 52 SKS PURPLE